**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[Soulburner]

Up and running now with Ace-a-Rue's Heatpipe/Heatsink mod.

IP35 Pro
E6850
2x1GB Crucial Ballistix @ 5-5-5-15-30-2T

Running OCCT at 400x9=3600mhz @ 1.320v (CPU-Z)

I found that to have multiplier control you must disable EIST, which is a bummer. I tested 450x8=3600mhz and got an extra 1,000 points in 3DMark2001 which is roughly an average gain of 2-3% per game test. Seems small but if its free, I'll take it. Only problem is I can't run that setting with EIST on otherwise it tries to run 450x9 (default multiplier).

Loved seeing Car Low, Dragothic Low, and Lobby Low all max out at 999fps though

At these settings uGuru is reporting that the PWM temp is just hitting 50c after 30 minutes of OCCT which is pretty good I did not add any fans to my heatsinks as I think its overkill - I have an NZXT Zero case which has 4 side fans, 2 rear, and my heatsink is the Enzotech Ultra-X which blows downward on the surrounding area (PWM, NB, etc). System temp shows 37c.

Maybe since 3600mhz was so effortless I should bump up my goal a bit. I need to take advantage of this RAM - I didn't buy it to run it at stock!