**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[SpinCykle]

I think your on to something lulhed. I dont use WC on any area of the board. But this board seems very senstive to FLEX. I had to rma my board because i over did it when i did the bolt through mod for the heatpipes, iam postive that is why my board was being flakey. Ive since done the mod again, withless torque, and all is fine..flex is non existent.

Maybe time for a RMA and the purchase of a backplate to stop the flexing of the board. Really wish i could figure this problem out. Ive loosenedd the CPU WC block screws as much as possible and still no go.

Edit: going to check for a grounding issue somewhere in the case. maybe that could be whats causing the 8.2 error code, i highly doubt its the pcp&c