Quote Originally Posted by ChaosMinionX View Post
Your using auto #1 so the board is adjusting voltage to compensate for the increase in FSB regardless. My chip takes more voltage at 500x7 than it does 400x9 or 450x9.... Set your vcore to like 1.45 or so and see if it posts, then check it again..that was your first mistake to setting it to auto.

Not to mention theres several other factors that come into play, but with my B3 quad on the other rig...it reports 3.6ghz (set to 400x8) CPUZ and all other programs read 3.2ghz. Its a BIOS error, nothing more.
You're saying use a voltage of 1.45 for 400x8? Should it take that much to do 3.2? Sheesh, what would I have to bump it to for 400x9 then? What I'd like to do is try to run it at 450x8, since I've read a few places that this runs cooler than 400x9 for some reason (the CPU, not the chipset).