just got myself a Q6600 stepping G0 and 2x1 Gb Cellshock PC6400 CL4.

When trying to overclock them i was only able to reach 360x9 FSB with the memory at 450 MHZ 5-5-5-12.
Then i tried to lower the FSB so i could test the RAM at 400 Mhz at 4-4-4-10, no problems there.

I then raised the FSB to 400x9 and RAM at 1:1 4-4-4-12 at 2.10 Vdimm, now it wouldnt Post.
I tried to boot with the same settings except i let the BIOS set the timings pr SPD, it booted but the timings was set to something like 6-8-8-16, at 400 MHz??

Do i need to raise the SB/NB above the minimum non-auto settings?
And lastly how much current can i give the RAM and the SB/NB when i dont have any aftermarket cooling?

I have a Antec 900 with 2x120 mm in the front, 1 120 mm in the side window, a 200 mm on the top and a 120 mm in the back sucking air out, so the air is being replaced pretty quickly.

I hope theres someone that can help me with this, its pretty frustrating to have spent a fortune on the best parts and then only getting a mediocre result.
Especially because the individual parts work fine when tested individually, but not together

If you need more info or if you need me to explain it better ill try, thank you all in advance.