7600gt vmod plz

[natedog420]

i need the mods to this card i believe i might have found them but not to sure. if anybody can help i would appreciate it a lot. thanks

http://www.newegg.com/Product/Produc...82E16814130062

[xtant25]

I have the same card and i used this guide to volt mod mine.....http://forums.vr-zone.com/showthread.php?t=119227

[natedog420]

tested this and works great no problem. here it is will confirm vgpu tomorrow. thanks to tostino for the pic

EDIT: both mods confirmed and fixed the one. the vmem with a 10k went from 1.75 to 1.83-84 just pluging it in so i changed it to a 50k and it work good. updated pic. hope this helps some people. i did NOT soldier on this card but i used ide wire and wrapped it around the ICs leg and super glued the wire on the board. ill try to get a good pic of it ill do that now.

EDIT 2: i know its kinda messy but it works very good . it was hard to get the ide cable wire around the ICs leg but there is just enough room. i made a little bend and got it around the leg. used very small flat head screwdriver to bend it more. then i used tweezers to pull it out and wrap the wire tight on the leg. i pulled the wire over both ICs and super glued the wire to the board to hold it there for good.

[natedog420]

updated with new pics ^^