Quote Originally Posted by philgood View Post
I'm running a Q6600 at 3200MHz at the moment with GA-P35-DS3P. Here's my bios setting:
- CPU Clock Ratio [8]
- CPU Host Clock Control [Enable]
- CPU Host Frequency [400]... 8X400 = 3200!
- C.I.A. 2 [Disable]
- System Memory Multiplier (SPD) [2]... This is the tricky part; [2] set the memory speed ratio at 1:2 to the CPU Host Frequency (2x400 = 800 MHz), [2.5] will be 1:2.5 which set the memory speed at 1025MHz (You need very good RAM to run at this speed!
- High Speed DRAM DLL Setting [Option 1]
- DRAM Timing Selectable [Manual]... You can use [Auto] to use RAM default RAS/CAS
:
:
:
- System Voltage Control [Manual]
:
- CPU Voltage Control [1.33750]... This board has some voltage drop and the actual CPU voltage is around 1.26-1.28 at this value.

And please also turn you "Caps" off when posting messages.
Sorry my caps were on because no one listens to you on this forum. You have to be clocking since 1645 to be heard I guess.
Here are my full specs

Trying to reach higher bu to no avail.
Processor E6320
board P35 Ds4
minne Crucial Ballistx tracers 2gigs PC2 6400 (can really be clocked I understand)

FSB 400
CPU Host Frequency: 1.86
PCI Express Frequency: default
C.I.A.2:disabled
System Memory Multiplier (SPD): 2
Memory Frequency (MHz): 800

#CAS Latency Time:4
#DRAM RAS# to CAS# Delay:4
#DRAM RAS# Precharge:4
#Precharge Delay (tRAS):12

System Voltage Control:
DDR2 OverVoltage Control:+0.2v
PCI-E OverVoltage Control:default
FSB OverVoltage Control:default
(G)MCH OverVoltage Control:default (same result med +0.025)
CPU OverVoltage Control:1.400v


NOW I have other problems.
Installed drivers 163.44 for my 8800GTS 640 graphic card. GRAW2 crashes and Lost Planet hangs. After countless installation and reinstallation of new and older drivers. I tried playing on default clocks, 1860 mhz, and my games work! Not what I want!
When i reset to my 400FSB clocks (2800mhz) TAT reads the speed at 2400mhz!. CPUz says multiplier x6 but its set at x7 in the BIOS.
WHAT gives ?

BIOS F3