Asus P5K "Vanilla" vmods

[Learn]

So are you saying that you can solder say a 1Kohm variable resistor in parallel with the 681ohm resistor in the pic and this will "fool" the DAC ?

It seems to be working just fine. (i can't say more, there is nothing on the "typical application circuit" in the datasheet for that pin.

thanks for info i'v cheked the 681ohm resistor has 20 ohm to ground from 1 side and 700 to ground on the other side, must be just solder 1k or so to ground on 700ohm side
or solder in paralel on that resistor.

i'm a litle confuzed, it will be needed vid mod on cpu? you just talk on this mod and vdroop mod, why no v-core mod? you substitute vcore mod by vid mod on cpu?

realy thanks

Solder a wire on each red points to your VR (set at 1000 Ohms) then decrease the resistance.
No need VID mod.
For the vdroop it is much better with, but it's not needed.
Do not use the other vcore mod, only that mod (without OVP).
That vcore mod only work when you set over 1.6000v in the bios.

(when i hit 2.10v (DMM) the monitoring say 0.024v)

PS: and thx to the dude of the pic (link on my previous post)

Again, lot of vcore = dangerous, beware.
Voila

[|RickY|]

i'll tryit soon

have you tryed to enter windows @ more than 1.92v ? i can get more than 1.92v on bios but not on windows, the max i try was 1.96v on bios ok but when it enters windows, restart.

[Learn]

I tryed 2.02v, it was OK.

[|RickY|]

cool, so it's an alternative v-core mod. i'll tryit very soon, thanks can you point-me to what fets and chips overheat?

thanks

[Learn]

The "phase without heatsink". Pic1 Pic2 Pic3 Pic4 (big)
I'll add some heatsink for the next serious bench meeting

[|RickY|]

for me worked good too

[Learn]

Very nice OC
It worked for you too, perfect