I have a P35-DS3R board. At 1.45v bios, speedfan reads 1.39v idle/load 1.34v

I tried to measure VCORE with DMM just like this guide:

http://www.vr-zone.com/index.php?i=4966&s=10

However, at load BIOS 1.45v, i read 0.4 on DMM.
Its set to 20V DC having units X.XX I have red point to point in picture and black touching ground metal of case.

Am i doing something wrong? Is this the right place to measure Vcore. It looks to be the bottom right point of that chip/mosfet? if the board's I/O connectors are facing to the right. There seems to be 4 of those points on that mosfet and ive tested the bottom right but end up getting wrong reading?