TJ07 + PA120.3 + PA120.2 = Photos of my version of this.

[JvT]

I thought I would throw up a quick photo of what I feel is one of the most useful mods you can do to this case when watercooling it...



I put some 'modder's mesh' perforated metal sheet in place of the stock vents. This stuff, the hexagonal shaped mesh with 79% open area flows much much better than stock. Stock is roughly ~45% or so open area. Very big, very noticable difference in air flow. Also available at McMaster, but as one piece from Mnpctech does both vents on a TJ07, seems to be more economical to buy it from there.

Just as you, my WC setup is made for low/no noise. How will you describe the audiolevel of your fans after you replaced the stock mesh with "Modders Mesh"?

[AndyM]

Just as you, my WC setup is made for low/no noise. How will you describe the audiolevel of your fans after you replaced the stock mesh with "Modders Mesh"?

I havent noticed much difference.

Any measurements yet?

Im hoping a BIX120 will only take up the bottom 3 5.25" bays :o

Here ya go...

The DVD drives go only as far as the very bottom of the 'C' shaped cutout in the side panel.



This should give you an idea...

BIP held up roughly to the fan screw holes it could be mounted to.