**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[anomalos]

Crucial 2GB Kit DDR2-1066 Ballistix??
TeamGroup 2GB Kit DDR2-1066 Xtreem??

[The Viper]

Crucial 2GB Kit DDR2-1066 Ballistix??
TeamGroup 2GB Kit DDR2-1066 Xtreem??

using Crucial Ballistix DDR2 1066 now, no issues as of yet, currently running stock speeds with 4-4-4-12 timings@2.35volts. Have yet to try for DDR2 1200

[Navig]

What's up?

Anyone have a decent solution for custom cooling of the PWMs?

I supposed one could cut the heatpipe?

Do you think individually taped microcool sinks with a small fan would be sufficient? How about copper?

I'm a little wary of cutting up a larger heatsink, because I do have concerns that not all of the chips will make contact with a custom single piece heatsink, unless I steal the thick stock tim pad.


What are some solutions that folks are using? Certainly someone is watercooling the nb, how are they cooling the pwm?


Current overclock: 9*400 Ram@400mhz 5-5-5-15 bios 1.0
e6600 (29b), crucial anniversary, ifx-14, corsair hx620, evga 800gts


Also, if you are interested in the ip35 and performance with the Thermalright IFX-14 and Ultra120X, check out my review.

[Ace-a-Rue]

What's up?

Anyone have a decent solution for custom cooling of the PWMs?

What are some solutions that folks are using? Certainly someone is watercooling the nb, how are they cooling the pwm?

well...i did this to enhance the cooling solution with the heat pipe system installed:

http://www.xtremesystems.org/forums/...&postcount=751

[MADMAX22]

using Crucial Ballistix DDR2 1066 now, no issues as of yet, currently running stock speeds with 4-4-4-12 timings@2.35volts. Have yet to try for DDR2 1200

What mobo are you using them on the IP35 pro or the one in your sig. If your on the IP35 pro your way overvolting for what you need to get those speeds and timings. This wboard should do that with 1T at 2.17vdimm or so.

[The Viper]

What mobo are you using them on the IP35 pro or the one in your sig. If your on the IP35 pro your way overvolting for what you need to get those speeds and timings. This wboard should do that with 1T at 2.17vdimm or so.

the IP35 Pro. Unforunataely that was the voltage necessary to stabilize in memtest, anything less then 2.35 and I would get errors

EDIT: Also though Im on the original BIOS, maybe flashing to the most current one will stabilize the RAM a little