Quote Originally Posted by Borgod View Post
Cheers AndyM,

I'll have a closer look when I receive my TJ07 next week.

Good question about the airflow for such a rad. It will be used for cooling the mosfet, NB & SB blocks so I'm not after near-ambent temps by any means, however with next to no airflow it may defeat the purpose of watercooling at all. I may have to use my PA120.2 for these blocks, and mount a second PA120.3 outside of the case to cool my QX6700 and SLI 8800GTX's.

I'm up for a challenge

Yeah, you'll have one heck of a heat load there for sure. One thing that is possible you could do for a small seperate loop for mosfets/nb/sb is something like this: If you check the photo of my HDD cage in my case, a single BIP or one of the MCR's can be installed over the fan for the hard drives. Then one of the 9 watt DDC's with 3/8" barbs can be installed on the MB tray over by the memory area. Then a bit of 3/8" tubing to route the loop, and that should work out pretty nicely. It wont be near ambient by any means, actually near-case water temps . But it will allow full Thermochill capacity for that quad and g80's.