Originally posted by G H Z
Hey Bowman, do you build your own phase Change system's, or modify the Chip-Con unit's?

I want to build my own and have some skill/knowledge, and an old mini fridge sitting here, but that's it. One thing I was curious about.....is it possible to cut the evap line and seal it quickly so you do not loose the charge? Heh, yes I know, but actually I think there is a way.

Sorry if this does not fit into the topic

G H Z
yes there is a way...it is hard to do but it can be done.

you have to crimp the copper tubing very very tightly in 2 places leaving a couple of inches of gap between the 2 crimps.then cut though in the middle,then with a good torch brase the cut ends quicky.this isnt easy sometimes.i dont even bother because i just pump the refrigerant into a empty cyl and use it for testing later.then cut the ends normally.but most of the time what i get to is empty anyways