Striker Extreme won't boot with 1303 bios.

[REVHEAD]

Mine boots ,you did reset to bios defaults before flashing?
I do find with this bios I need to add more vcore for the same overclock I had on bios 1301, I was running 1400mhz fsb on stock volts with old bios on this bios i need to run 1.4 volts very strange.

[Ambro]

Sorry to hear mustang

I would try the others suggestions.

FYI 1303 allow me to go beyond 449Mhz FSB () to 500+ (still testing - using a 2.66 e6750 @ 3.6 as I type .. )

keep trying if you board allows - although I must admit you need active cooling on a 680SLI board if you want results.

[hipro5]

Hmmmm.......Two things might have happen.....
1. Bad flashing and
2. Same problem I had with bios 1301...

1. Try to find a friend of yours bios chip or mobo so to hot flash yours and
2. IF you use "SLI Ready" memory modules, you HAVE to take them out and place into slot one DDR Module NOT "SLI Ready" (ex. a 533 one) to boot.....AND IF you are trying to boot with VGAs in SLI config, take them of and place only one or a PCI VGA.....

@ Ambro: Does this bios have AGAIN the HTT frequency option? (SP > MP frequency below the PCI-E frequency settings?)

[cliffy]

Fixed mine thank god, pulled the battery for a couple minutes then held down the clear cmos button for 30 secs and it works again.

[mutang]

Yay I'm back on track that battery trick worked also for me. I waited approximately 1 hour.

After the screen went on I just noticed in the bios there was a CMOS Checksum error so I loaded the default setting and it works well so far.

But i can't guarantee that this will work for all of you so be careful when flashing your striker bios.

thank you all for your help

[Ambro]

@ Ambro: Does this bios have AGAIN the HTT frequency option? (SP > MP frequency below the PCI-E frequency settings?)

Yes it does - I've set mine from 'auto' to the base 200 -> until you tell me if I can get better results by changing it ........

FYI.... probe (V1.04.19b) results:
FSB @ 1940
HTT 1.44
VCore 1.41
1.2VHT 1.42
NB Core 1.5
Memory 2.10

[gmod]

So what bios do I have to have to flash to to see a 1333fsb chip. Iam on 1004 right now.

[hipro5]

Yes it does - I've set mine from 'auto' to the base 200 -> until you tell me if I can get better results by changing it ........

FYI.... probe (V1.04.19b) results:
FSB @ 1940
HTT 1.44
VCore 1.41
1.2VHT 1.42
NB Core 1.5
Memory 2.10

From Auto to 290MHz (145MHz PCI-E), I gained ~600 marks in 2k6....

[mutang]

After the update to 1303 my onboard usb controller stopped to function.

Anyone with similar experience ?