1333 FSB Mod, Confirmed To Be Working By Me.

[hollo]

sweet. ok i just thought of another little problem... check out post #12 here http://www.xtremesystems.org/forums/...d.php?t=111510
the pin mod described shorts a BSEL H and a BSEL L to create two BSEL Ls. according to wikipedia an open-drain output should work like that (ie if you have a string of open-drain outputs on a single line then the voltage line will stay high until one of them is brought low, at which point the line will become low). but there have been quite a few mods done by shorting a BSEL L with a Vcc to bring them both high, some of which worked. they might have just worked 'despite' the ground in the circuit because the Vcc pins overwhelmed the small circuit, since they're power supply pads, while the BSEL pads are for a low current sensor circuit. perhaps what needs to be done to bring a BSEL from L to H 'properly' is to insulate the pad, then paint over it with conductive paint, so that there's no ground/BSEL L in the circuit. i think some people have already picked up on this idea from what i read in other threads. does anyone who had no luck the first time feel like trying it again with an insulator + Vtt ;D?