Sapphire X1950GT pencil volt mod?

[JamesBong420]

opps here is the 3d05 link.. sorry.

http://service.futuremark.com/compare?3dm05=3195437

im using some of the goo that came from the stock heatsink to hold my sinks on. and it doesn't work very well. i have no sinks on the back. i have quite a few extras that i might epoxy on, and redo all the others. then i bet the memory will break the 860mhz wall im at.. even with 2.0v on the mem it wouldn't go past what i had with stock 1.8.

do you guys know if the 1950pros have a coldbug? i would only be going to -30c res temp.. chiller on the card and cheap water on the cpu.

have fun moddin it up.. what kind of cooling are you using trans?

[trans am]

opps here is the 3d05 link.. sorry.

http://service.futuremark.com/compare?3dm05=3195437

im using some of the goo that came from the stock heatsink to hold my sinks on. and it doesn't work very well. i have no sinks on the back. i have quite a few extras that i might epoxy on, and redo all the others. then i bet the memory will break the 860mhz wall im at.. even with 2.0v on the mem it wouldn't go past what i had with stock 1.8.

do you guys know if the 1950pros have a coldbug? i would only be going to -30c res temp.. chiller on the card and cheap water on the cpu.

have fun moddin it up.. what kind of cooling are you using trans?

This is fun! I have a few things I can use for cooling. i think the easiest would be my thermalright HR-03 Plus with a high CFM 120mm fan and some sinks on the bottom of the card(8800gts) and for the x1950 i have an old mcw50 I can use or a drilled/modded stock cpu heatsink I can bolt on through with some sinks. I also have a VF-900 and fan controller but not sure if that will cut the heat?