Who's using a Lian Li PC-343 Cube?

[virtualrain]

Nah mountain mods are common as muck, and look far too custom and industrial.

I've only ever seen one in the flesh and it just screamed out 'custom made box, bolted together'.

It's definitely a matter of personal taste. The MM cases are well designed and well built... no arguing that.

For me, the MM cases are more at home next to a snap-on tool chest in the garage than in the den. It's really just personal taste.

Modding the Lian Li will not be difficult... just adding a new aluminum back plate with a pre-built motherboard tray (perhaps even from MM) will be trivial.

Mekrel, how much is laser cutting costing you? I want to have some additional holes cut into the top plate as well and may use laser cutting on the rear panel if its not too pricy.

[Mekrel]

Not sure how much it will be costing me as of yet, around 35 pounds roughly I think. I've sent the piece off and the design, just waiting to hear back.

I'm sat with my finger over P5K board, don't know if to buy or not

[virtualrain]

Not sure how much it will be costing me as of yet, around 35 pounds roughly I think. I've sent the piece off and the design, just waiting to hear back.

I'm sat with my finger over P5K board, don't know if to buy or not

What do you have to provide the laser cutting shop in terms of guidance as to what/where to cut?

[Mekrel]

What do you have to provide the laser cutting shop in terms of guidance as to what/where to cut?

I provide them with google sketchup images with measurements etc.