ASUS P5K Deluxe - Intel P35 Bearlake + E6600 B1 / Q6600 B3

[burningrave101]

I interpreted it as him not being satisfied with the stock cooling in general and having parts to handle NB and mosfet. His inquiry about sb was asking if he needed any at all.

My heat pipes are working pretty well so far too, but it gets pretty warm around nb/cpu/ram and I'm eventually going to be trying it out with some other cooling just to see.

I dunno. I'm running 515Mhz FSB on mine with only 1.4v NB and stock SB and the NB and the rest of the heatpipe assembly don't hardly get more than warm. I don't even have direct cooling on the NB sink at the moment since I took out that extra 120mm fan I had mounted above my video card. Right now I just have a rear 120mm exhaust and two 120mm fans blowing down over the motherboard. My NB temp right now running small fft's is only 28C. Jumps up to low to mid 30's on large fft's.

[dekruyter]

4gb of Crucial running here; also no heat problems; doesn't even get warm at 460 fsb.

[mrcape]

I dunno. I'm running 515Mhz FSB on mine with only 1.4v NB and stock SB and the NB and the rest of the heatpipe assembly don't hardly get more than warm. I don't even have direct cooling on the NB sink at the moment since I took out that extra 120mm fan I had mounted above my video card. Right now I just have a rear 120mm exhaust and two 120mm fans blowing down over the motherboard. My NB temp right now running small fft's is only 28C. Jumps up to low to mid 30's on large fft's.

That's good to hear, I haven't gone that high fsb yet or rigged any loose fans around in there. I do intend to do that with one 40mm two 120s and an 80mm nmb fan that blows like a devil. I am having a lot of fun with this board.