[First Look] DFI 680i LT NF-680i LT SLI (56K Warning~~~)

[nugzo]

I have a couple of issues... not sure if these are just me or widespread:

1) (Minor) nTune can't see a lot of the voltages, bus values, etc. for this board.

2) (Minor) Speedfan sees the +3.3V value as 1.22V

3) (Major!) I can't install Vista x64 on this board without BSOD. I tried 3 times. Same result. It may be the crappy MX 4000 video card I'm using for bench testing but the driver is there in Vista x86 so I'd be surprised if it wasn't included in x64. Otherwise, I'm doing a bare-bones install.

Can anyone else see if they can install Vista x64 on this board?

BTW, it's prime stable overnight on stock settings (on Vista x86). Ready to go to the next step!

Remove one of your 2 gig sticks. It should install with ok with 2gb. Do all windows updates then put memory back in. For me with the EVGA i would still sometimes get the BSOD on boot, i would let it bluescreen and loop and it would eventualy make it to desktop. Then i would run windows update again with the 4gigs in and i would get a single update concerning X64 hardware compatibility. i would never get this update with only 2gb installed. after i installed that update i was good to go. would run fine from then on out. Again this was with EVGA 680i. This was the only way i could get it to install and run with more than 2gigs of ram.

edit: also i had problems installin x64 while overclocked.