Quote Originally Posted by just_Frank View Post
Lowering mem voltage should be a 2-minutes easy task ( if only I knew how much ohms to put in in order to obtain -0,05 / -0,1 volts less ), I'm curious to see how much this improves stability...
Ok.. if you really want to test I calculated resistor values (using the equation shown in the guide) and get following values:

~ 9000 ohm -> 2.5 V
~ 16000 ohm -> 2.6 V
~ 60000 ohm -> 2.7 V

.. but I suggest to put potentiometer/fixed resistor (high value) in series and adjust & measure voltage in the same time !! Good luck and be careful