PA120.3 To shroud or not to shroud ?

[ladderman]

Great. I will probably go down the same route then. But please post results.
Will be a few weeks before i got the project in full flow (no pun intended ).

If you want those fans you got to get them in the USA cos no one stocks them over here.

I read loads of reviews about low CFM fans for rads and these always came out on top, most other makes are crap!

The only down side of ordering in the US is it cost for shipping.

My fan order came to 48 dollars and the express shipping was 37dollars. But because goods are always cheaper in the US it didn't workout too bad, about £43 in total

[nattoNrice]

yeah the pa when useing standard fans like the yate loons goes just fine with out a shroud however if u use 38mm fans on it (like i do, so u know im not rippen this outa my butt (><) ) then the shroud is a must. anything above 5v on 38mm fans makes the dead spot huge and the sucking noice is crazy!