Quote Originally Posted by deees View Post
I love it!

I was just starting in one of those this weekend. Are you bolting it through the aluminum block with threaded stock?

I'm planning on using 1/8" x 3/4" stock. Your looks like the horizontal pads are closer to the mounting holes than the original. I’m planning to try to maintain the same geometry of the original because I like the springs I’m using and need the additional length.

Do a thread on it with some photos/drawings and a material list.
I'm just sliding #8 x 1.5" stove bolts into the finned aluminum HS, where the original brackets clipped into. They will be kept in place with electrical tape wound around both brackets, until I can find some screws long enough to fit all the way thru that finned alum. top piece.

You are very observant! These brackets are mounted further away from the mobo. Two reasons why-interference with the capacitors underneath them, and my back bracket bolts are quite long (they stick thru the backside about an inch with the stock mounts).

I'l like to see pics of what you end up with, too!