New TJ07 cooling project...could use your help/ideas

[Pete]

LOL and go with no power supply heh? There's no space for two 480s.

Can you fit two 480s in a lian li v2000b plus II if you stack them on their sides? Also, what about airflow? I was thinking of grabbing a v2000b, but I don't know how two rads in the bottom of that case can achieve decent airflow with the fans affixed to them. There don't appear to be any ducts except on the bottom and back.

Give the measurements i'll check right now for ya!!

Intake from both side and have some fans along the top of the rad to draw the air/heat up and thus stopping the rads blowing at each other a lot! PSU can be made to fit dude!

[masaville]

Height 133 mm, laying on it's side, would have to fit underneath that power supply
Lenght 517 mm
Thickness 54 mm + 25mm for the fans - so each is 79mm wide, plus you need room for the barbs using 90 elbow fittings, an extra 70 or so, more is better

Total width would have to be about 228.

According to Lian-li the case measurements are 210x617x625 mm. It's tight. Not sure if it the rad on it's side would fit underneath the base of the power supply mounted on the top.