Stuck with VERY low FSB @ DFI LAN Party UT nForce 4 Expert DR

[Lastviking]

Try this....And with one stick still!


Cpu vid startup value: 1.45v
Cpu vid control:1.XXv(give this value so you have 1.48v with + 104%
cpu vid special 104%
LTD voltage control: 1.4-1.5v


In memmory tab...

DDS : 1
DDDS : auto

Max Asynd :9
Read Preamble:6

What bios are you using? also...If thats not work i will try another way...

[Littleluk]

Hey there,
I managed to boot and bench with a 334 htt @ 3ghz with one Kingston 512 stick and TRC = 12, TRFC = 16, TRRD = 4, TRAS = 8.

Well, I tried it with a single GEIL stick and the same settings and could only boot with 280 htt. Anything past 280 doenst even show the windows booting sequence, the system reboots after showing that table (that one before the windows logo shows up). I think / hope its a timing issue ... Everything I know about that GEIL sticks is whats written on them: CL 3-8-4-4.

vDDR is 2.66 but acually seems to be aroud 2.75

Can anyone help me ?

Memory Settings:

[learners permit]

Mixing ram IC's and O/C ing them just never seems to work as their drive strength needs are seldom in common. If you insist on pursuing using four dimms and O/Cing the try running even ram drive strengths and odd data drive reduction on the Ram. I'd start at 6 and 3 respectively.

[Lastviking]

Mixing ram IC's and O/C ing them just never seems to work as their drive strength needs are seldom in common. If you insist on pursuing using four dimms and O/Cing the try running even ram drive strengths and odd data drive reduction on the Ram. I'd start at 6 and 3 respectively.

You got the point there

[ozzimark]

also, set all the timings other than the primary 4 to auto. yes, that includes max async latency and read preamble

what pci devices do you have? what bios are you using?