I started my pc up as normal this morning and the pelt wouldn't draw any amp's? I tested the psu it works with a 172w. Why would such a new pelt just quit working like that? (its days old) The wires are attached just fine.I assembeld it w/aritic silver. Is it neccesary to soft start them? low v/? By the way I was running the recomended 15v and the pelt drew 24 amps on the nose. My psu is more than enuff its rated 15v 36amp's.
Then I'm not sure about the pelts performance w/the Danger Den Maze 3. my chiller cooled the non tec set up just as well. But then it was a reall strian on the chiller it self. I couldn't belive the amount of heat the tec produced. I made a helper for my chiller i made a cool can out of a 5gal water cooler w/50 feet of cooper tubing filled w/ice. I think I will try the swifteck tec block next since I need a new pelt any ways.
Bookmarks