Quote Originally Posted by Serge84
It seems to work with the new bios only. And your new rev 1.3 but I'm on a backup powersupply so I can't say. I'm going to buy a OCZ powersupply so atleast I have control over rails.

Prob always been my limit all a long before. 12v rails on my comp suck even a $50 powersupply for 9 months at 500w wouldn't give me good rails 11.84v most of the time. So a $150 OCZ is the one to get if I want to keep powerful overvolted rails for OCing.
You mean the Biostar OC tool doesn't work with your board?
Hmm.. I'll check with Biostar regarding this.

Btw, note that the OC tool will always default to 266HTT or something different that set at BIOS. This is because the prog was designed such that it will load up "safe overclock" values on launch. So make sure you run CPU-Z first before launching the OC tool.

One of my readers owns an older rev and he had no issues getting the Vcore over 1.6v with the tool.

Seriously, this board does extremely well throught the software rather than the BIOS. If you hate the fact that the Biostar tool resets your OC, you can always mod the BSPanel.ini file located in the prog folder.