FW 85.96_mod for SLi on any chipset

[jcmiro]

OK i installed the drivers (85.96 hacked) for the card then rebooted added second card attached brdge turned on installed the driver for second card, rebooted, enabled sli bridge rebooted.....ran 3dmark06 and three games and Im getting great scores but there is these red bands that come accross the screen and turn the screen almost entirely red....the cards are not artifacting...I increased and decreased clocks to no avail...I tested the cards separately and they both work fine.....I ran drivercleaner and installed the cards fresh three times, and still I get the red banded stuff....only when I run in SLI mode....any thoughts....I even switched back to an old lcd I had and still red crap everywhere...

[The Nemesis]

OK i installed the drivers (85.96 hacked) for the card then rebooted added second card attached brdge turned on installed the driver for second card, rebooted, enabled sli bridge rebooted.....ran 3dmark06 and three games and Im getting great scores but there is these red bands that come accross the screen and turn the screen almost entirely red....the cards are not artifacting...I increased and decreased clocks to no avail...I tested the cards separately and they both work fine.....I ran drivercleaner and installed the cards fresh three times, and still I get the red banded stuff....only when I run in SLI mode....any thoughts....I even switched back to an old lcd I had and still red crap everywhere...

Are you using the asus flex bridge?

[Big_Sam]

Are you using the asus flex bridge?

SLi will work without the SLi-bridge.

Hi!

I have been trying to setup my two msi 7600GT with Asus flexible SLI Bridge on my Intel 975bx board. No matter how i tried, i can only see one card. I cannot turn on the sli function in the advance properties setup. I took out and use the driver clean to clear off the drivers and then put in the card one by one and still the same. Can anyone here who has the intel 975bx board advice me on the setup procedure of ur sli setup. Btw, i run my e6300 at default mode. No overclocking.

Thanks

Regards

CW

If you see in system only one card, your problem not in the driver.
You can install any other driver and be convinced of it.
I repeat once again, it is not necessary SLi-bridge for SLi work, SLi will work without it but only more slowly.

i was really close to doing SLI with 2 7960gt's. But after reading this thread im gonna do CF instead. x1900xt 256 or a x1900xtx, for only $70 the xtx seems like a better deal

Good choice.
Only do not regret about it then.

[cloudwinds]

hi.

im using asus flex bridge. anyway, im going to delete my win xp n reinstall the xp again n then install the driver again. do i install one card by one card or put two card in one time? really appreciate if u could advice on this.

thks.

regards cw

SLi will work without the SLi-bridge.



If you see in system only one card, your problem not in the driver.
You can install any other driver and be convinced of it.
I repeat once again, it is not necessary SLi-bridge for SLi work, SLi will work without it but only more slowly.



Good choice.
Only do not regret about it then.

[Big_Sam]

hi.

im using asus flex bridge. anyway, im going to delete my win xp n reinstall the xp again n then install the driver again. do i install one card by one card or put two card in one time? really appreciate if u could advice on this.

thks.

regards cw

There is no difference how to install cards.
I always install both cards simultaneously.
To install cards one by one - more time will demand.