Quote Originally Posted by eva2000
haven't measured via dmm only software heh but i believe the droop is correct

3.6ghz out of the box was easy as pie hehe

not sure about VRM cooling i have the heatpipe on but reapplied TIM on it and have removed those covers as i stated above


corrected typo SATA1 hehe, 9x440fsb isn't stable going to drop multipler to find the max fsb.. i have timings manually enabled never SPD with no probs

1.65v MCH i would consider safe if you have the cooling i'd probably change the stock NB heatsink if you want to run it 24/7 - i'm going to use Thermaltake Extreme Spirit II NB heatsink since i'll take it off my Bad axe hehe



re-read 1st post stock heatpipes with covers off, reapplied TIM and fan over them.. haven't tried 4:5 yet i've only had this P5W DH for less than 48-72hrs need time to test hehe


thanks mate...


i had to raise my MCH from 1.55v to 1.65v to get 9x400fsb = 3600mhz at 1.376v stable as i reported in 1st post at 1.55v it will error out in stressprime after a few minutes

as to questions of where my ES came from, i could tell you but i'd then have to kill ya LOL

more results coming soon
Hehe, well I dont need to know neither, they're quite easy to get
Was to the "on retail FSB" part
Hmm, this is odd, I use alot higher vcore, but thats quite normal for step6, also due my board has MAJOR Vdroop.
Hmm, one odd thing though, my mem, they wont run P95 stable at speeds even 100mhz lower than benchable.. - They do 4-3-2-4 at 530mhz, but wont do 4-3-2-4 at 400mhz, odd..? I'd like 4-4-4-4 at 500mhz, gonna give it a shot with raising the vmch, but cant really see that helping, but if theres a chance, its sure worth doing