P5W DH - Chassis Intruded! ???

[safm]

My board is crazy:

It's new, arrived today, but when i power on, after the bios post:

Chassis Intruded !
Fatal Error... System Halted!

And i can't do anything, no access to the bios, nothing. I read the manual, but the Chassis Intrusion jumper is in default. Already claered cmos, but the same.

I don't now what to do.

Any ideas?

Sorry about my English.

[Tranzmit]

First of all what bios no is wriitten on the bios chip? Mine came with a 401 which wouldn't work till it was updates to at least 601 or up (currently i'm on 1101). Still haven't got a conroe though so i bought a celeron to tide me over and flash it

[safm]

Yes, it's writen, it's 0701, and it recognize perfectly my E6600, but that is not the problem.

[caater]

check out your manual for chassis intrusion detection header pins.
probably you miss a jumper from there.

[safm]

check out your manual for chassis intrusion detection header pins.
probably you miss a jumper from there.

With or without jumper the problem is the same.

[xpsentity]

With or without jumper the problem is the same.

Remove that thing, clear cmos, pull battery, wait a bit.

Then redo w/out intrusion and try.

[Igor01]

I've had a similar problem, took out the CMOS battery, reset both the Chassis Intrusion and the CMOS jumpers and the problem was fixed.

[safm]

I've had a similar problem, took out the CMOS battery, reset both the Chassis Intrusion and the CMOS jumpers and the problem was fixed.

i took out the battery abou 14 hours and, restarted but problem still there. 1 question, when we remove the cmos battery, it cleans the cmos, correct? because when i removed the battery i didn't move the cmos jumper to clear position.

[speks]

i took out the battery abou 14 hours and, restarted but problem still there. 1 question, when we remove the cmos battery, it cleans the cmos, correct? because when i removed the battery i didn't move the cmos jumper to clear position.

You have to:

1. Remove the battery
2. Change the position of the clear_cmos -jumper for 10 secs
3. Change the jumper back to it's normal position
4. insert the battery back
5. Voila!

[lawrywild]

mine did this, just restarted it a few times and it corrected itself..

[Frank M]

i took out the battery abou 14 hours

You're a patient man.
Even a few minutes are enough...

[Tranzmit]

lol 3 secs is fine to take out the battery but ensure you have removed the power cable from the power supply too or it'll keep it's settings. Simple as

[safm]

Nop,

Don't work with battery, without battery, with power, without power, clear cmos i don't know what to do.

Tomorow i'll go the store and changed the board.

But wich one:

> Asus P5W DH Deluxe
> Gigabyte GA-965P-DQ6

MY System is:

OCZ GameXStream 700w
Conroe e6600;
Asus P5W DH Deluxe or Gigabyte GA-965P-DQ6
2 GB Gskill 6400HZ
Club 3d 7900gt
XP-90c

Thanks everyone for your help.

once more, sorry about my english.