does the DS4 suffer from same DS3 problem ?

[egyteam]

I read DS3 has problem detecting right timmings with DDRII 800MHZ CL4, the board will auto boot with CL3, which result to unbooted board, does DS4/ DQ6 suffer from same problem ?

[realsmasher]

where did you heard of such a problem ?

[ost_2005]

I read DS3 has problem detecting right timmings with DDRII 800MHZ CL4, the board will auto boot with CL3, which result to unbooted board, does DS4/ DQ6 suffer from same problem ?

Yes,ds4 has the same problem

[realsmasher]

what can you do to this ?

i was going to use ocz platinum (4-5-4-15) together with the ds3.

no way to get in bios ?

[realsmasher]

i dig this thread out, cause this is really important.

thx !

[Gun_Strife]

what can you do to this ?

i was going to use ocz platinum (4-5-4-15) together with the ds3.

no way to get in bios ?

im plannin same ram and mobo
but havent really heard much bout that problem

[realsmasher]

i don't really want to buy an extra stick of crap ram, just to get in bios

somebody with ds3 and cl4 ram, please test this.

[mearle73]

Thats what happens with my g.skill zx,have to enter the bios useing an odd stick of dd2 533,save as cas 4.The ds3 bios trys to boot at 800mhz cas 3 otherwise and that ant going to happen.

[realsmasher]

you tried with only one stick of the g.skill ?

if it's really not possible without an other stick, i can't buy this board...

[Phosphate]

Well I have DS-3 and OCZ Pc2-6400 4-5-4-15 platinums and no problems, but then again I am using a celeron with a 533 bus.

I haven't even tried OCing this CPU or even updating to F3 bios (lol..I know) but maybe I better manually change to cas 4 and maybe up to volts to 2.2 before I install my Core 2 duo?

Anyone have any opinions?

[realsmasher]

the board would ran on 533mhz ram at first too(not overclocked conroe =266fsb)

but i'm not sure if it works or not.

the ram would have to work under 533/cl3, where 800/cl4 is normal.

really hard to say

[mikael999]

somebody have a fix to this problem ?

[dinos22]

the problem isn't applicable to conroe/allendale runners...............as the PC starts up with 266MHz FSB

i have HZ sticks and that's what happens...................................no problems with them whatsoever

[realsmasher]

the problem isn't applicable to conroe/allendale runners...............as the PC starts up with 266MHz FSB

i have HZ sticks

you have what ?

cl4 on gigabyte ds3 first bootup and it ran without problem to bios ?