Originally posted by NoFuture
Why don't you glue an small heatsink (ramsink?) on your core, I think that would improve performance a lot!
Actually....I was thinking of trying something along those lines...something like that would produce some turbulence with the fins. I tend to think that just a direct flow over the die itself will prove best. I want to try it without anything first to see how it does, but that's a good idea. I might stick one on there to see if there is an improvement. That would mean using 2 chips instead of one because I doubt I will be able to separate the chip from the top block without damaging it. That means also that I need two identical chips to judge any improvement. The cost just doubled.