Final clarification regarding Conroe MB support

[The Stilt]

Before PCB 1.03G rev seems that p5wd2-e+conroe wont work. Clear as water...


@ The Stilt: how did you rework your P5WD2-E ?? Im curious

- Certain pin of PWM Buck Controller lifted
- Lifted pin connected to certain voltage
- Certain voltage connected to certain pin of the socket
- Certain pin removed from the socket
- Few added resistors that connect certain traces

That was pretty much it.
Before the rework diagnostic card gave only two slashes (which pretty much means nogo). After the mod it just hangs because of some bios issue.

I am pretty sure that it would work with proper bios and according to certain mb engineer it also would

[freecableguy]

- Certain pin of PWM Buck Controller lifted easy
- Lifted pin connected to certain voltage - I know which one...
- Certain voltage connected to certain pin of the socket yep, found it
- Certain pin removed from the socket ???
- Few added resistors that connect certain traces found these too...

That was pretty much it.
Before the rework diagnostic card gave only two slashes (which pretty much means nogo). After the mod it just hangs because of some bios issue.

I am pretty sure that it would work with proper bios and according to certain mb engineer it also would

So close...
Need that BIOS though...