OCZ DDR Diagnostic Booster Works on these Motherboards.

[Black Phoenix]

But you had tested on DFI nf4 all models, and as i know this board is 24 pin atx. So it's proved that he have to try and then say something, right...

[RyderOCZ]

But you had tested on DFI nf4 all models, and as i know this board is 24 pin atx. So it's proved that he have to try and then say something, right...

AndyT (AndyOCZ) tested on his personal board and found it to work, yes.

Officially, OCZ does not test the booster on any of the 24pin motherboards

[andyOCZ]

But you had tested on DFI nf4 all models, and as i know this board is 24 pin atx. So it's proved that he have to try and then say something, right...

The DFI boards have extra power connectors on the board and handle power differently than most boards. Some boards don't even use the extra 4 pins on the 24 pin at all. Some boards will blow up iof the booster is used. If you try it you could have a bad experience unless you know it is a working combo.

[Black Phoenix]

I understand, so if i use on my Asus A8N32-SLI i'm at my own... But if it works i can post here right... Let's see if i have the guts to try it...

[RyderOCZ]

I understand, so if i use on my Asus A8N32-SLI i'm at my own... But if it works i can post here right... Let's see if i have the guts to try it...

That is correct
It helps also to have a PSU with the 20 + 4 connector, because you can leave the 4 off, connect to the booster harness, plug the booster harness into the mobo, then add the 4 pin directly into the remaining slots on the ATX connector

[Black Phoenix]

Well my PSU is like that kind of config, 20 pin + 4 pin. So part of the test is done...

[Black Phoenix]

As i had said, i had tested on A8n32-sli... Results: voltage corrected detected, waiting for new memory to test (OCZ VX). For the ones that want to help me, use slots a2 and b2, if ddr don't interfear with ocz resistor... Possible dual channel problem because of the layout (slot a1 - capacitator interfear with ocz heatspreader)...

[OverCool]

Did OCZ DDR Booster running fine on DFI CFX3200 ATI RD580 mainboard??

Or just use the onboard 4V jumper. Which 1 is more stable?

[phi|os]

What is this booster?

[Black Phoenix]

What is this booster?

This is the booster: http://www.ocztechnology.com/product...gnostic_device

[gsan]

FYI,

Booster works on DFI NF3 Ultra-D.

[Kinsy]

FYI,

Booster works on DFI NF3 Ultra-D.

If it does, how?

Think i have rev1.1 - never used it with my OCZ 3700EB as it never worked.

Hooked it up to slot1 with 2&3 holding the memory.

On power up, it displays 25..26...27...28...29...got to 31 and i switched off. I set voltage to 2.6v in BIOS and was worried when i saw it steadily climb. No VGA signal was produced (i.e. no boot). Take it this is the voltage readout?

Got an OCZ Powerstream 520w for it.

As my 3700EB doesnt seem to clock well at all anyway over 220mhz fsb i doubt itll make much difference, but thought id give it a try.