Asrock 939Dual-SATA2 Vmods

[Asio]

The res richt to the left of the circle, infact the circle just touches the resistor.

Using the Vdroop pic

If the Vdroop resistor was shorted, it should just give a lower (and probably unstable) Vcore. If the Vdroop resistor was set to 10k, the board would have given a very high Vcore. The board would probably have shut down through OVP before it could cause too much damage tho.

I used the Vcore 1 mod to reach 1.7Vcore and was under the impression Vdroop only makes Vcore more stable not increases it.

I did have the board running with only the Vdimm and Vdroop mod without a hitch. Can I cut out the Vcore1 mod and still use 1.55+ vcore?

Edit: I have to confess, I accidently solder the Vcore1 mod to the leg of the chip above it (arrow above just touches the chip named A2
Vr set at 8.5K and may verywell be the reason of my strange bios behavior. I experienced the same problem after flashing the bios early this weak so I took little notice of it, just sharing with you.

ps. Would this mobo be able to reflash my infinity B bios chip? (4mbit I think)