Quote Originally Posted by Asio
I ran into trouble.

After booting with Vcore Vdroop and Vdimm mod I coudnt acces bios nor could I flash the bios (flash.exe error)

Im afraid I used a to high Vdimm (3.4) and to low Vcore (default 1.4 and using the mod 10k VR, 1.55)

Im even considering a leg of the Vr came loose (bit of a blanc there)

I removed the Vcore and Vdroop mod to resolder them.
Doing so I accidently damaged the resitor (vertical R on the left) next to the Vdroop mod.
Can someone tell me its value?

Any change to revive it?
A Vdroop off 10k or even worse short cirquited results in?
Can you mark the damaged resistor on a picture of the board?

If the Vdroop resistor was shorted, it should just give a lower (and probably unstable) Vcore. If the Vdroop resistor was set to 10k, the board would have given a very high Vcore. The board would probably have shut down through OVP before it could cause too much damage tho.