Quote Originally Posted by Cisco
Couple of questions about OC stability:

When changing the K8 to NB multiplier down to 3X (600) or whatever...

1... is there a need to also adjust the SB to NB frequency or should that remain @ 1000? (I think I read the "leave @ 1000" somewhere but I forget where now )

2. How about the link mode: Auto? 16/16, or 8/8..or does this matter?

1. DO NOT change this, if I run anything lower than 1000 for SB to NB, 3d becomes totally unstable (I think this is a SLI thing). 3dmark05 will run, but FEAR will crash.

2. Link mode at Auto or 16/16