The Official Opteron 939 Overclocking Thread

**SPivX** · 11-11-2005, 04:08 PM

Originally Posted by mascaras

so no one with a 144 CABNE 0540 BPMW to post results????

i had 3 of them, 2 RMA'd and 1 currently testing. It's SuperPI 32M stable @ 2430 @ 1.392v. Will try to push harder, but i don't think this thing will go much higher. I already tried to do a SPI run @ > 2500 MHz, but i need a lot more voltage.

Go for a CABYE 0540, they should still be available and chances are fairly high that you will hit 3GHz with good cooling.

**Lastviking** · 11-11-2005, 04:14 PM

This one is for Garret

, Garret what cooling do you use?

**Nights Dawn** · 11-11-2005, 04:23 PM

Hi there, short term lurker and my first post - I got a CAB2E 0540 FPMW the other day, and I am extremely dissapointed

I am having to run it at 2475mhz at 1.55 volts currently - anything higher clock wise and it fails all of my stress tests, within 6 seconds. Even with 1.6volts and slightly higher - 2700mhz on 1.65v is a no go. Super pi fails doing the 128k calculation never mind the 1m calculation.

Using an NF3 Ultra (Epox 9NDA3J) even back flashed to what is considered the best o/c BIOS of the April 2005 version.

I have an AKASA 460W Paxpower CPU,
XP-120 with L1A Panaflo fan
x800 xt pe

I think the CPU is just a really poor clocker, I have tried with the timings and ram dividers on the lowest they can go - but no luck. So far I have run about 10 hours of SP2004 and I think the clock speed I am at is stable now. Also the HTT is set at 3X (275HTT)

Temps under load are 47-49C

Peter

**zetachi** · 11-28-2005, 11:18 AM

Originally Posted by Nights Dawn

Hi there, short term lurker and my first post - I got a CAB2E 0540 FPMW the other day, and I am extremely dissapointed

I am having to run it at 2475mhz at 1.55 volts currently - anything higher clock wise and it fails all of my stress tests, within 6 seconds. Even with 1.6volts and slightly higher - 2700mhz on 1.65v is a no go. Super pi fails doing the 128k calculation never mind the 1m calculation.

Using an NF3 Ultra (Epox 9NDA3J) even back flashed to what is considered the best o/c BIOS of the April 2005 version.

I have an AKASA 460W Paxpower CPU,
XP-120 with L1A Panaflo fan
x800 xt pe

I think the CPU is just a really poor clocker, I have tried with the timings and ram dividers on the lowest they can go - but no luck. So far I have run about 10 hours of SP2004 and I think the clock speed I am at is stable now. Also the HTT is set at 3X (275HTT)

Temps under load are 47-49C

Peter

hmm I seem to be in the same boat with my 144 locks up @ 285 can run stable @ 280 ?? maybe