"402 XTREME" in action! Take One: Breaking 3GHz barrier!

[bachus_anonym]

If you ever saw an ihs out of a proc, you know that at that point is thicker than the center and the a64 ihs is is overall thicker than the ihs in p4, you can not take any real proc temp from the ihs.
How your delta pressures betwin idle and load?

Hehe... That I know even too well. That's why I was not trying to say that -24C LOAD is CPU temp, but CPU IHS temp. And still, not the best measurement there is as It's impossible to get it attached closer to the middle of the IHS, where actual core is. If you have better idea how to get as close as possible to real CPU die temp measurement, then let me know Without removing a heatspreader, that is
I still believe that even after the IHS is removed, temps would be much lower than what MBM or Speedfan are showing. I just can't imagine that there would be -24C on IHS and +5C on a DIE. It just looks way to much of a difference.

What exactly you're asking me about?

How your delta pressures betwin idle and load?

I just figured what you asked me about... Well, I can't measure that. I'm just a OCer, unfortunately I have no skills/tools/gases/instruments to built my own phase change. So I'm not able to answer that question for ya

EDIT: Can you run EXACTLY same test, with same method at your MAX Prime95 SmallFFT stable config?

EDIT: I'm leaving in few minutes, so I can answer to any other questions later today...