DDR533 2 2-2-2 Prime95 Warm Up

Just a simple run

Of course using DFI LP nF4


DFI RDs are so great to design 2 steps DRAM voltage
2.5~3.2V
3.3~4V
But you need JUMP17 to adjust it.

Even you save a big money for buying special POWER and module to make DRAM run over 3.3V, however, please be careful the temperature as motherboard user manual mentioned – when you use JUMP17, please strengthen surround cooling.

Before using JUMP17, set it as 3.2V, the software display 3.07V, running P95 5 minutes later the temperature as shown below:



After using JUMP17, set it as 3.2V, the software display 3.07V, running P95 5 minutes later (Room Temperature is 20 degree C)
Actually this value is I stick on Mosfet heat sink.
If I stick on Mosfet, the value will break 100...


As DFI said, the surrounding capacitors and resistors are high thermal endurance.
When you use Winbond memory chip with ultra high voltage, please consider the motherboard cooling first, then is memory.
DDR533 optimization is making feeling great...