People using a USB mouse or a keyboard with the DFI NF4 take a look.

[formyfaith]

I had a lot of friends here having similar stability issues,

but has been fixed so simple.

If you are using a USB Mouse or a Keyboard, be sure to change

the USB Power selection jumper from 5V(pins 1-2) to 5VSB(pins 2-3)

This jumper is located on the upper left side of the board.

Right next to the dimms.

Before doing it, my friends experienced similar stability issues.

Most of them were sometimes unable to post,
(with the no signal on the screen, 4 leds lit)

or could not get into the bios randomly, because the system

would hang up with the logo screen on.

But after the above procedure, everything runs so smooth.

And I am very satisfied with my NF4 SLI-DR