DFI NF4 Ultra/SLi-D BUGS and Fixes Thread

[AMDnewbie]

well, after rcv my sli-d yesterday. I was having a hard time setting it up...
its a Rev. A01 board w 25/01/2005 bios.

suddenly i had to pump 3.0v for my corsair XMS 3200 XLPT rev 1.2 for 200Mhz @2-2-2-7-1T and my TCCD take it....

The only difference is just an additional cooling fan being installed between this n my GA-K8NF-9 as it was hot on the giga board.

Any voltage less than 3.0v, my tccd would fail super pi w rounding errors...

wonder the vdimm voltage as display by smart guardian is correct or not...

anyone having similar problem w this ? have to depress F10 straight away at bios after using page up/down else cannot change voltage at all....

I touch the heat spreader of the TCCD and it was actually cool !

now i m lost....a calibration error ?