I tried the vmem mod, soldered one wire to it, looked like it was good to me, didn't put the other wire, or the pot on just the single wire. Nothing else was connected, the resistor that it was soldered to did not looked burned or anything. So I put it back in my comp, to go check that it was the right resistor before I connected the pot and did something stupid. And at first it wouldn't boot up, made some error beeps. So I just yank the wire off. Still the error beeps. So I take my recently soldered caps off, even tho they were connected perfectly fine, I had the same problem before when the caps were connected yet one of the leads had been broken, so I thought maybe it was a similar issue.

So... took those off, comp. booted up, no error beeps. But now I got blocks all over my screen . I check the vddr voltage and I get no reading. Think this might be fixable?