Quote Originally Posted by choseone214
Opp make yourself one of these.
http://www.jason57.iwarp.com/msineo2/o.jpg

use #6 bolts and since the holes are just big enough in the mobo for #6 make sure you drill accurate. after you do the 9 holes place the mobo in the support and make 2 #6 holes where you would use the hold down then apply 2 3in #6 bolts to the board with the exact same height as the stand offs with the washers and so on so it looks like this
http://www.jason57.iwarp.com/msineo2/s.jpg

add some foam like this
http://www.jason57.iwarp.com/msineo2/r.jpg

install it and get this
http://www.jason57.iwarp.com/msineo2/p.jpg
http://www.jason57.iwarp.com/msineo2/q.jpg

I gaurt you nothings going to warp at all as I uses some massive force now wihtout any issues.. If you get my design right you could add 200lbs force to the chip wihtout a warp anywhere.

I had issues rem and I think this was my cure.
Sorry for being offtopic here but whats all the red liquid on the mobo jason? Some kind of insulation?

OPP, that 38K is looking good. Good luck with the 'serious' benching

The DFI SLI-DR is looking good... me will have to pre-order one.

Why cant OPP, Big Toe and OPB wait till its out in the shops before they start to tease us with hardware that the 'normal' xtremesystems overclocker cant get yet