I like that all the VRMs are 0.26mm. No need for a thermal pad I'm not sure if the screw pattern is the same on all of these bottom plates (I think this is a stock photo) http://shop.watercool.de/epages/Wate...Products/79272 then there will still be at least two holes left to secure the block, which is enough Also, there will be at least 0.25mm clearance from the block down to the tallest cap... maybe I should try to shave a mm off the block, but not sure if it's needed. Will find out when I get the parts... Some non-conductive tape or similar is probably a good idea to avoid more fireworks :p

Anything not sorted out yet...? I think I'm ready to order, no...?