Theses are the tech specs posted on amazon for this fan (not sure how accurate they will be or if the 0.33a is based when running at 12v):

Application PC case or heatsink fan
Dimension 120 X 120 X 25mm
Fan speed 600 -1300 RPM
Max airflow 57.53 CFM (97.74 m3/h)
Max static air pressure 2.64 mm H2O
Noise level 6.9 -16.05 dB(A)
Current rating 0.33A
Voltage rating 12V DC
Bearing HDB (Hydro Dynamic)
Fan life expectancy 50,000 hours
Connector 4pin PWM

Acutech - Thanks for the link, cable wise i'm ok as i'll just custom wire my own if needed to fit in with everything else i've got braided up.

Do we think theres any need to watercool the Aquaero 5 for my setup?? I've cooling power spare so its an option if required but would be easlier if I won't be stressing the controller too much to keep it on air.

Also while I think on it, how is the software temp reading on MSI gear (specifically a P67A-GD65).. I'd prefer to use the software values taken from hardware rather than wiring up the temp probes from the controller - from reading this thread If I understand right this will be possible.