Swiftech MCP 35X

[gabe]

I thought about drilling a fill port in top not going to happen as I would probably need 1000w Drill press.

The Cutaway area for the ports not large enough to use compression fitting ( 3/8-5/8 BP and koolance) or any fitting with a larger lip.

both of the above will be corrected in the next production batch:

- top will have an additional G1/4 fitting, and be made out of Delrin (see * note)
- spacing between ports will allow large compression fittings (note how I worded the subject on the web page: "Compression fittings up to 1/2" (tube OD) are currently supported."

*Note: this will reduce weight, and the reduction in material cost should almost offset the extra cost for machining the port + the plug