One observation I just made and I'm not sure what it may indicate.
I monitoring the rpm's on the pumps through the mb and EasyTune6. I just noticed that now the pump rpms are up from the previous setup.
Before they were at 1700-1704 rpm and now the are reading 1735-1739 rpm. Would that indicate an increase of flow? pumps not working as hard?
I added 2x 90deg fittings to the setup that should have added some restriction to the loop.
The only other thing that has changed other than adding the RX120 is the male to male rotary that was connecting the two pumps has been removed and I moved the pumps up higher in the case.
Just curious, may not indicate squat haha
Reply With Quote
Bookmarks