X6 1035T @ 300x13.5, 4GB Memory @ 1600MHz, Post 1 Of 2
Initial setup. Just like the 4A89TD Pro this board allows locking in the Turbo multipliers in the BIOS. Because of this good CPU overclocks can be obtained without the need for extremely high bus frequency. The downside is the CPU being a non-BE it has a max NB multiplier of 10x so the higher the bus frequency the better the memory performance.
ASUS Crosshair IV Formula, 0707 BIOS
Phenom II X6 1035T
2x2GB OCZ Reaper (OCZ3RPR1800LV6GK) PC3-14400 1333MHz 8-8-8-26
300x13.5, Memory @ 1600MHz 7-7-7-21
OCZ 100GB Vertex LE100
SAPPHIRE 4870x2, 4870 Trifire
OCZ Z Series 850W
click for larger image
click for larger image
click for larger image
click for larger imageCode:Configure System Performance Settings ---------------------------------------------------------- Target CPU Frequency:. 4050MHz Target DRAM Frequency: 1600MHz CPU Level Up......................[Auto] OC Tuner Utility AI Overclock Tuner ..................[Manual] CPU Ratio............................[13.5] CPB Control..........................[Disabled] CPU Bus Frequency....................[300] PCIE Frequency.......................[100] DRAM Frequency.......................[1600MHz] CPU/NB Frequency.....................[3000] HT Link Speed........................[3000] > DRAM Timing Configuration > DRAM Driving Configuration ************* Please key in numbers directly! ************* Extreme OV...........................[Disabled] CPU & NB Voltage Mode................[Manual] CPU Voltage........................1.429 [1.400000] CPU/NB Voltage.....................1.442 [1.412500] CPU VDDA Voltage.....................2.560 [Auto] DRAM Voltage.........................1.700 [1.65000] HT Voltage...........................1.310 [1.27500] NB Voltage...........................1.310 [1.27500] NB 1.8V Voltage......................1.802 [Auto] SB Voltage...........................1.111 [Auto] VDDR Voltage.........................1.205 [Auto] VDDPCIE..............................1.113 [Auto] DRAM CTRL REF Voltage................0.500 [Auto] DRAM DATA REF Voltage................0.500 [Auto] ********************************************************** CPU Load-Line Calibration............[Auto] CPU/NB Load-Line Calibration.........[Auto] CPU Spread Spectrum..................[Disabled] PCIE Spread Spectrum.................[Disabled] DRAM Timing Configuration DRAM CAS# Latency....................7 [7 CLK] DRAM RAS# to CAS# Delay..............7 [7 CLK] DRAM RAS# PRE Time...................7 [7 CLK] DRAM RAS# ACT Time..................21 [21 CLK] DRAM READ to PRE Time................4 [Auto] DRAM Row Cycle Time.................28 [28 CLK] DRAM WRITE Recovery Time.............8 [Auto] DRAM RAS# to RAS# Delay..............4 [Auto] DRAM READ To WRITE Delay.............7 [Auto] DRAM WRITE To READ Delay(DD).........2 [Auto] DRAM WRITE To READ Delay(SD).........4 [Auto] DRAM WRITE To WRITE Timing...........4 [Auto] DRAM READ To READ Timing.............4 [Auto] DRAM REF Cycle Time................110 [Auto] DRAM Refresh Rate..................7.8 [Auto] DRAM Command Rate...................1T [Auto] DRAM Driving Configuration DCTO Information: CKE drive strength................1.5X [Auto] CS/ODT drive strength.............1.5X [Auto] ADDR/CMD drive strength...........1.5X [Auto] MEMCLK drive strength.............1.5X [Auto] Data drive strength.................1X [Auto] DQS drive strength..................1X [Auto] Processor ODT...................60ohms [Auto] DCTO Information: CKE drive strength................1.5X [Auto] CS/ODT drive strength.............1.5X [Auto] ADDR/CMD drive strength...........1.5X [Auto] MEMCLK drive strength.............1.5X [Auto] Data drive strength.................1X [Auto] DQS drive strength..................1X [Auto] Processor ODT...................60ohms [Auto] CPU Configuration AGESA Version 3.7.0.1 ---------------------------------------------------------- AMD Phenom(tm) II X6 1035T Processor Revision: E0 Cache L1: 768KB Cache L2: 3072KB Cache L3: 6MB Speed : 4063MHz uCode Patch Level: 0x10000BF ---------------------------------------------------------- Microcode Updation..................[Enabled] Secure Virtual Machine Mode.........[Enabled] Cool'n'Quite........................[Disabled] C1E Support.........................[Disabled] ASUS Core Unlocker..................[Disabled] CPU Core Activation.................[Manual] 2nd Core..........................[On] 3nd Core..........................[On] 4nd Core..........................[On] 5nd Core..........................[On] 6nd Core..........................[On] DRAM Controller Configuration ---------------------------------------------------------- Channel Interleaving................[Auto] MemClk Tristate C3/ATLVID...........[Disabled] Memory Hole Remapping...............[Enabled] DCT Unganged Mode...................[Always] Power Down Enable...................[Disabled]
click for larger image
Code:x264 HD BENCHMARK 3.0 RESULTS Please do not compare it with older versions of the benchmark! Please copy/paste everything below the line to to report your data ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ Results for x264.exe r1342 -------------------------- encoded 1442 frames, 92.52 fps, 3898.70 kb/s encoded 1442 frames, 92.35 fps, 3898.70 kb/s encoded 1442 frames, 92.34 fps, 3898.70 kb/s encoded 1442 frames, 92.44 fps, 3898.70 kb/s encoded 1442 frames, 38.37 fps, 3971.80 kb/s encoded 1442 frames, 38.51 fps, 3972.09 kb/s encoded 1442 frames, 38.58 fps, 3951.22 kb/s encoded 1442 frames, 38.69 fps, 3968.90 kb/s System Details -------------- Name AMD K10 product System Product Name Codename Specification AMD Phenom(tm) II X6 1035T Processor Core Stepping Stock frequency 3100 MHz Core Speed 4063.5 MHz FID range 5.0x - 15.5x Northbridge ATI ID5A11 rev. 02 Southbridge ATI SB750 rev. 40 CAS# latency (CL) 7.0 RAS# to CAS# delay (tRCD) 7 RAS# Precharge (tRP) 7 Cycle Time (tRAS) 21 Command Rate (CR) 1T Memory Frequency 802.7 MHz (3:8) Memory Type DDR3 Memory Size 4094 MBytes Channels Dual, (Unganged) Windows Version Microsoft Windows 7 (6.1) Ultimate Edition (Build 7600) Number of processors 1 Number of threads 6 Number of threads 6 (max 6) L2 cache 6 x 512 KBytes, 16-way set associative, 64-byte line size Instructions sets MMX (+), 3DNow! (+), SSE, SSE2, SSE3, SSE4A, x86-64 Package Socket AM2+ (940) Package Type 0x1 Temperature 0 34°C (93°F) [0x22] (TMPIN0) Temperature 1 30°C (85°F) [0x1E] (TMPIN1) Temperature 0 16°C (60°F) [0x7E] (Core #0) Temperature 1 15°C (59°F) [0x7B] (Core #1) Temperature 2 16°C (59°F) [0x7C] (Core #2) Temperature 3 16°C (60°F) [0x7F] (Core #3) Temperature 4 16°C (61°F) [0x82] (Core #4) Temperature 5 16°C (61°F) [0x83] (Core #5)
Reply With Quote
Bookmarks