All good i worked it out. Thanks Churchy i worked it all out, all good
I used a 220om resister and paralleled my LED's in a sequence of 4.
Anyways on to how i got to the end product.
So the first step was to mark out where the mobo went. From the back side of the mobo tray.
I marked it out with masking tape and then marked 30mm in from the outer edge of the mobo to get my placements for my LED's.
Marked the middle of the mobo at top and bottom.
Then Drilled 5mm holes for LED's to go thought.
hear what it look like after that. (pic as follows).
Reply With Quote
Bookmarks