Watercooling case design I wish I could make.

[Power5]

With Mick as my inspiration, I decided to model a case I would like to see somehow built. Not ever going to happen with my finances today. Anyone is free to turn this idea into reality if they would like.















Dimensions would be approximately 10" wide x 26" deep x 24" tall. So yeah, big. But fits 2x quad 120 rads up top with 25mm push/pull fans exhausting out the side vents. Top quads are fed by 6x 92mm fans in the roof. Bottom fits 2x triple 120 rads with 25mm push/pull fans exhausting out the side vents. Bottom triples are fed by 4x 92mm fans in the base. Other fans are a 200mm HDD front fan and 140mm PSU intake fan in the floor and 140mm rear exhaust fan. My vision was for the tall reservoir to have the caps hidden out of view in the top and lower section. Pump would be hidden in the top and bottom section and tubes would be routed as most route cables today. They would route behind mobo and just pop through to connect. Not sure if thats even possible though.

What do you think?

Edit, just realized that I cant space the PSU up. So no intake fan for PSU, it will just sit on bottom mesh. This will give room for the GPU hoses to route into the mid plate. PSU is a 1500w silverstone dimension.