Alright, a couple smaller things...
As I got to looking at the HDD cage, I noticed that when it's full, the bottom hard drive won't really get any air from the fan in front. (yes, it will be full, eventually.) So, I decided to fix this by adding a fan on the bottom. 80mm fan fits right in there.

Drilled holes in the bottom panel of the case. Can you guess which one I did and which one is stock?


Yeah looks like garbage. I'm just gonna take the 3" hole saw and use mesh. Even though that won't get seen, I know it's there....

Also, the door sans hinge is annoying. I'll fix that. I'll start by cutting off the rolled over metal.




Jeezas that was a pain.
I cut off the corresponding rolled metal on the case. I don't seem to have a picture of that part right now....

I used a solid hinge, mainly because I knew that if I used a few smaller hinges, I wouldn't get them all lined up right and it would just piss me off.

Cut a few areas in the hinge to get around rivets and such.

Good ol' JB Weld to the door.


Yeah, so the picture isn't all that great, cause I ahem kinda goofed. I used wax paper when I clamped the hinge to the door, to keep the clamps from getting glued to the door. Well, it wasn't wax paper like I thought, so the paper stuck to the door. Nice.
I will sand this all down, and if im not happy with how it looks, I'll just cover it in some bondo. Same with the half that's in the case. I have to figure out some way to cover that up, maybe another piece of that panelling, mebbe just simple sheet metal, idk yet.

I'll do the same for the minicase.